Juniper SSG-140-SH Spezifikationen PDF herunterladen (Seite 35)

Resetting the Device to Factory Defaults  35

Chapter 3: Configuring the Device

3. Release the pinhole button, and wait two seconds.

4. Push the pinhole button again for four to six seconds.

The message “2nd push has been confirmed” appears.

5. Continue to press the pinhole button until the device resets.

The system now resets and returns to the login prompt; the default login name

and password are both reset to netscreen.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 59 60

Security Products 1
Copyright Notice 2
FCC Statement 2
Disclaimer 2
Table of Contents 3
4  Table of Contents 4
About This Guide 5
Organization 6
Conventions 6
Requesting Technical Support 7
Opening a Case with JTAC 8
Feedback 8
Hardware Overview 9
Port Descriptions 10
Device Status LEDs 11
Ethernet Port LEDs 12
Reset Pinhole 12
USB Port 12
Back Panel 13
Fuse Cover 14
Power Switch 14
AC Power Appliance Inlet 14
Chapter 2 15
Before You Begin 16
Installing Equipment 16
Installing Equipment  17 17
Organizing Interface Cables 18
Connecting Power 18
Configuring the Device 21
Accessing the Device 22
Using a Console Connection 22
Using the WebUI 24
Using Telnet 24
Default Device Settings 25
Basic Device Configuration 26
Admin Name and Password 26
Administrative Access 27
Interface IP Address 27
Management Services 27
Hostname and Domain Name 28
Domain Name System Server 28
Date and Time 28
Default Route 29
Bridge Group Interfaces 29
PIM Configuration 30
Basic Firewall Protections 30
Restarting the Device 31
Device Serial Number 33
Reset Pinhole Button 34
Servicing the Device 37
Replacing a PIM 38
Removing a Blank Faceplate 38
Removing a PIM 39
Installing a PIM 40
Upgrading Memory 40
Upgrading Memory  41 41
42  Upgrading Memory 42
Replacing the Fuse 43
44  Replacing the Fuse 44
Specifications 45
Electrical Specifications 46
Environmental Tolerance 46
Certifications 47
Connectors 48
Pin Signal 49
50  Connectors 50
Initial Configuration Wizard 51
1. Rapid Deployment Window 52
2. Administrator Login Window 52
4. Untrust Zone Window 54
8. Confirmation Window 57
Index  59 59
60  Index 60

Kommentare zu diesen Handbüchern

Keine Kommentare

Juniper SSG-140-SH Spezifikationen Seite 35

Kommentare zu diesen Handbüchern