Juniper SSG-140-SH Spezifikationen PDF herunterladen (Seite 11)

Front Panel  11

Chapter 1: Hardware Overview

Device Status LEDs

The device LEDs show information about current device status. Figure 2 shows the

position of each LED on the front of the SSG 140 device.

Figure 2: Device Status LEDs

When the device powers up, the POWER LED changes from off to green and the

STATUS LED changes from off to blinking green. Startup takes approximately one

minute to complete. If you want to turn the device off and on again, we recommend

you wait a few seconds between shutting it down and powering it back up. Table 2

lists the name, color, status, and description of each device status LED.

Table 2: Device Status LED Descriptions

Name Color Status Description

POWER Green On steadily Power is functioning correctly.

Off Device is not receiving power.

STATUS Green Off Device is powered off or is starting up.

Blinking Normal operation.

ALARM Red On steadily Critical alarm:

 Failure of hardware component or software module.

 Firewall attacks detected.

Amber On steadily Major alarm:

 Low memory (less than 10% remaining).

 High CPU utilization (more than 90% in use).

 Session full.

 Maximum number of VPN tunnels reached.

 HA status changed or redundant group member not

found.

Off No alarms.

HA (High

Availability)

Green On steadily Unit is the primary (master) device.

Amber On steadily Unit is the secondary (backup) device.

Off High availability not enabled.

PIM (1-4) Green On steadily PIM is ready for activity.

Blinking Traffic is present.

Off PIM is not present or is installed incorrectly.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 59 60

Keine Kommentare

Juniper SSG-140-SH Spezifikationen Seite 11