Juniper CX111 Handbuch PDF herunterladen (Seite 12)

APPLICATION NOTE - Configuring the CX111 for J Series and Branch SRX Series Devices

set routing-options static route 0.0.0.0/0 next-hop 198.0.0.1

/* NAT conguration */

set security nat source rule-set Outbound-NAT from zone trust

set security nat source rule-set Outbound-NAT to zone untrust

set security nat source rule-set Outbound-NAT rule Nat-All match source-address

0.0.0.0/0

set security nat source rule-set Outbound-NAT rule Nat-All match destination-

address 0.0.0.0/0

set security nat source rule-set Outbound-NAT rule Nat-All then source-nat

interface

/* Zones and policies */

set security zones security-zone untrust interfaces ge-0/0/0.0 host-inbound-

traic system-services ping

set security zones security-zone untrust interfaces ge-0/0/1.0 host-inbound-

traic system-services dhcp

set security zones security-zone trust host-inbound-traic system-services ping

set security zones security-zone trust interfaces vlan.1 host-inbound-traic

system-services dhcp

set security zones security-zone trust interfaces vlan.1 host-inbound-traic

system-services ping

set security zones security-zone trust interfaces vlan.1 host-inbound-traic

system-services ssh

set security policies from-zone trust to-zone untrust policy permit-outbound

match source-address any

set security policies from-zone trust to-zone untrust policy permit-outbound

match destination-address any

set security policies from-zone trust to-zone untrust policy permit-outbound

match application any

set security policies from-zone trust to-zone untrust policy permit-outbound then

permit

Monitoring

The 3G signal strength and connection status can be monitored from the CX111’s management interface, which is found

under status -> device info tab.

Figure 6: Modem status

1 2 ... 7 8 9 10 11 12 13 14

Keine Kommentare

Juniper CX111 Handbuch Seite 12